|
Boiler Sensor SR2
The SR2 is used for monitory conductivity in a boiler blowdown line. The SR2 cannot be used after a sample cooler.
- Body Carbon Steel
- Electrodes 416SS
- Insulator Peek
- Max Pressure 600 psi (41.4 bar)
- Max Temperature 460° F (238°C)
- Cable 20 ft High temp
- Process thread ¾ inch MNPT
- Conduit connection ¾ inch MNPT
Boiler Sensor SR4
The SR4 can be in the boiler blowdown line or with a sample cooler. The SR4 can only be used with the 2250 and 2255.
- Body 316SS
- Electrodes Titanium
- Insulator Peek
- Max Pressure 250 psi (17.2 bar)
- Max Temperature 392° F (200°C)
- Cable 20 ft High temp
- Process thread ¾ inch MNPT
- Conduit connection ¾ inch FNPT
- Temperature comp 4K NTC
MBV1 and MBV2
| MBV1 |
MBV2 |
| Size ½ inch NPT |
Size ¾ inch NPT |
| Body Carbon Steel |
Body Carbon Steel |
| Rating 250 psi @ 400° F (17.2 bar @ 204°C) |
Rating 250 psi @ 400° F (17.2 bar @ 204°C) |
| Seals Reinforced TFE |
Seals Reinforced TFE |
| Ball 316SS |
Ball 316SS |
PL5
The PL5 is used as a sample/cycle method in boilers. The orifice restricts flow near the boiler sensor to prevent steam flashing during a sample. The PL6 can also be used as a PL5.
PL6
The PL6 is used for a continuous sampling of a boiler. The lower orifice bleeds a small sample across the sensor. The upper orifice is used with the motorized ball valve and opens when the conductivity is above set point.
|
